Shoulders to Legs to Ankles

   Put the new drill press to use this morning by realigning the holes for the shoulder flanges and leg then glued up the two layers. Using the holes in the first layer I then drilled all the way through and rebolted the two sections together. Oops.. almost forgot to drill a hole for the wires to pass through from the body to the leg.  Outer layer is drying up with the smaller ankle bit and center leg is drying as well.

 Cleaned up the armpits so the details fit then sanded down the sides of the legs to even up the layers. And since I was making a mess I grabbed the ankle cylinders and cut/sanded off the extra bits on the backsides from when they were molded. Just need to fill in any small air holes then they're ready for paint.